The Honeywell IPCAM-WOC1 has four (4) dongles leading from the back of it. ![]() Performing the factory reset should fix this problem.Ĭomplete the following steps to reset the Honeywell IPCAM-WOC1 so that you can add it to a different TC2 account:ġ. If you try to pair the camera without performing the reset first, then you may notice the camera LED lights are acting unusually during the attempted registration process. After the reset, you can then add the camera to Total Connect 2.0. Another reason to reset the camera is if you replace your modem and/or router and the network settings change. This is often done if the camera is purchased used, and the previous owner forgot to delete it from their Total Connect 2.0 account. ![]() ![]() If you try to bring it to a new account, and you cannot perform the traditional deletion process through the original Total Connect 2.0 account, then you must perform a hard reset for the camera. You can then proceed to set up the camera with a new account like normal.Ī Honeywell IP Camera can only be deleted through the Total Connect 2.0 account that it is assigned with. ![]() This should be done while the camera is powered on. You can reset a Honeywell IPCAM-WOC1 to use on a different TC2 account by pressing and holding the reset switch until the LED light on the camera is blinking white.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |